TM 10-3930-675-24-2
HYDRAULIC RESERVOIR REPLACEMENT - CONTINUED
0262 00
REMOVAL - CONTINUED
10.
At top front of reservoir (4), remove three hydraulic hoses as follows:
a.
Remove four screws (26), flange (27), O-ring (28), and hose (31). Discard O-ring.
b.
Disconnect two hoses (32 and 33) from adapter fittings (34).
34
26
29,30
27,28
32
4
33
31
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use assistance
during procedure. Ensure that any lifting device used is in good condition and of suitable load
capacity. Keep clear of heavy parts supported only by lifting device. Failure to follow this warning
may result in death or injury to personnel.
Lifting device must have sufficient capacity to lift reservoir. Use a forklift truck with a 2,000-lb
capacity to remove reservoir. Failure to follow this warning may result in injury to personnel.
NOTE
Ensure forklift truck is positioned with forks raised to support reservoir prior to removing attaching
hardware.
11.
Remove six screws (29) and washers (30) securing hydraulic reservoir (4) to frame.
0262 00-5
