TM 10-3930-675-24-2
HYDRAULIC SYSTEM VALVE MAINTENANCE - CONTINUED
0263 00
SHIFT VALVE (6041) INSTALLATION - CONTINUED
5.
Connect electrical lead (11) to valve solenoid (7).
6.
Install clamps (and new tiedown straps, as needed) in position as noted during removal.
7.
At hydraulic reservoir, open any ball valve that may have been closed.
8.
Check oil level in hydraulic reservoir (WP 0051 00).
9.
Start engine (TM 10-3930-675-10) and check for leaks.
BOOM SUPPORT/BOGIE SUPPLY VALVE (6043) REMOVAL
NOTE
Refer to Foldout, FO-13 as a guide to remove hose(s) and fitting(s) from valve or component.
Note position of tiedown straps and clamps to aid in installation.
1.
Press in on retaining clip and disconnect electrical lead (17) from solenoid (16).
2.
Remove tiedown straps and clamps, as needed. Discard tiedown straps.
3.
Remove two bolts (22), nuts (23), washers (24), and valves (25) from mounting plate (18).
4.
Remove two hoses (20) and O-rings (21) from valve (25). Discard O-rings.
5.
Remove two fittings (19) from valve (25).
19
20,21
18
22,23,24
17
16
434-40200
25
0263 00-5
