TM 10-3930-675-24-2
HYDRAULIC SYSTEM VALVE MAINTENANCE - CONTINUED
0263 00
TILT OVER-CENTER VALVE INSTALLATION
NOTE
hydraulic hoses and applying proper torque.
Perform step 1 to install fittings removed from old valve, if new valve is being installed.
1.
Install four fittings (144) on valve (145).
2.
Lubricate and install four new O-rings (143).
3.
Install and tighten four hoses (142) on valve (145).
4.
Install valve (145) on mounting plate (148) with two bolts (146) and washers (147). Tighten bolts in accordance with
145
144
146,147
142,143
148
434-40218
5.
Install clamps and new tiedown straps as needed, in same position as noted during removal.
6.
At hydraulic reservoir, open any ball valve that may have been closed.
7.
Check oil level in hydraulic reservoir (WP 0050 00).
8.
Start engine (TM 10-3930-675-10) and check for leaks.
0263 00-24
