TM 10-3930-675-24-2
CYLINDER BLOCK REPAIR - CONTINUED
0271 00
DISASSEMBLY - CONTINUED
9.
If necessary, use universal puller and remove three idler gear ring dowels. Discard dowels.
IDLER GEAR
RING DOWELS
CLEANING
CAUTION
DO NOT damage vehicle surfaces when using wire brush or gasket scraper to clean cylinder block
surfaces.
NOTE
If rust or corrosion cannot be removed with abrasive pad or bristle brush, cylinder block MUST be
cleaned with chemical bath.
1.
Use abrasive pad or bristle brush and clean these cylinder block areas:
a.
Gasket surfaces
b.
Cylinder liner bores
c.
Cylinder liner counterbores
d.
Cylinder head deck
e.
Cup plug bores
f.
Main bearing saddles and caps
g.
Water passages
0271 00-5