TM 10-3930-675-24-2
PREPARATION FOR STORAGE OR SHIPMENT - CONTINUED
0283 00
PREPARATION FOR RETURN TO SERVICE FROM LONG-TERM STORAGE - CONTINUED
5.
Check oil and hydraulic fluid levels in engine crankcase, transmission, axle differentials, wheel hub ends, hydraulic res-
ervoir, and tophandler slewing and spreader motors (WP 0050 00).
6.
Check coolant level in radiator expansion tank (TM 10-3930-675-10).
7.
Install fully charged batteries (WP 0108 00).
8.
Tighten or install alternator drive belt and A/C compressor drive belts (WP 0071 00 and WP 0195 00).
9.
Remove seals from all engine openings, including air intake, exhaust outlet, and crankcase breather tube.
10.
Start engine (TM 10-3930-675-10). Idle engine 3 to 5 minutes to allow it to warm up. Verify all indicator and warning
lights operate properly on driver's ECS display screen.
11.
Drive vehicle without a load and check engine, transmission, brakes, steering, and electrical accessories for proper oper-
ation (TM 10-3930-675-10).
12.
Check operation of boom and tophandler (TM 10-3930-675-10).
PREPARATION FOR SHIPMENT
1.
Follow instructions in TM 10-3930-675-10 to prepare vehicle for these transport modes:
Highway Transport on M1000 Trailer
Rail Transport
Marine Transport
Air Transport
2.
Ensure RTCH transmission control lever is in Neutral (N) and parking brake is applied.
3.
Ensure RTCH wheels are securely blocked and adequate tiedowns are used.
4.
For rail and marine transport, seal all openings in engine, including air intake, exhaust outlet, and crankcase breather
tube.
5.
Check engine coolant to ensure coolant has correct mixture for expected temperatures (TB 750-651).
WARNING
Check travel route for overpass and bridge clearances. If clearances are not adequate, an accident
causing injury or death to personnel or damage to equipment could result.
6.
For highway transport, check state and local laws governing weight, width, and length of load.
END OF WORK PACKAGE
0283 00-3/(0283 00-4 Blank)
