TM 10-3930-675-24-2
BOOM SUPPORT REPLACEMENT - CONTINUED
0281 00
INSTALLATION - CONTINUED
13.
Install autolube system to boom support (USMC only) (WP 0141 00).
14.
Using eight bolts (11) and washers (12) install cover (10) to boom support. Repeat for other side.
15.
16.
17.
18.
Raise boom support completely (TM 10-3930-675-10).
NOTE
Raise boom to 19 degrees and extend to 110 in. (279.4 cm). During this process, always adjust to above
settings and pull center lever on boom folding valve to ensure folding cylinders are fully extended.
19.
CAUTION
After bushing alignment is achieved, lubricate locking pins with GAA grease. Extend locking pins to
ensure correct and smooth operation. Note sign inside of remote hydraulic control compartment. If
sliding pins bind, damage to vehicle may result.
20.
NOTE
Replace hydraulic reservoir return filters after 100 hours of operation (WP 0185 00).
END OF WORK PACKAGE
0281 00-10