TM 5-3810-306-34
2. INSTALL SCREWS (13) IN OIL TRANSFER
TUBE (11).
a. Apply Loctite 601 to threads of screws
(13).
b. Install screws (13) in proper ends of oil
transfer tube (11) and tighten until flats of
screws align with bottom of oil transfer
tube.
INSTALLATION:
1. INSTALL OIL TRANSFER TUBE (11).
2. INSTALL PUSH RODS (12).
3. INSTALL ROCKER LEVER ASSEMBLY.
a. Ensure adjusting screws
(2)
are
completely backed out.
b. Install rocker lever assembly over oil
transfer tube.
NOTE
Make sure dowel rings in
rocker lever support (5) are
installed into the dowel bores.
c. Lubricate capscrew (3) threads with clean
motor oil.
d. Install rocker lever clamps (4) and secure
with capscrews (3).
NOTE
4. ADJUST VALVES. (REFER TO TM 5-3810306-
20.)
To prevent damage to rocker
5. INSTALL VALVE COVER. (REFER TO TM 5-
lever or push rod make sure
3810-306-20.)
adjusting
screw
ball
is
positioned in the socket of
6. INSTALL ENGINE HOOD. (REFER TO TM 5-
push rod when tightening.
3810-306-20.)
e. Torque capscrews to 32 ft-lbs (43 Nm).
7. CONNECT NEGATIVE BATTERY CABLE AT
SHUNT. (REFER TO TM 5-3810-306-20.)
END OF TASK
4-55
