TM 5-3810-306-34
19.
REMOVE FLANGE (85).
c. Remove cup (120a), taper bearing (120b) and
washer (120c).
a. Remove nut (82), lockwasher (83) and
preformed packing (84). Discard packing (84)
d. Using press, remove taper bearing (111) and
and lockwasher (83).
washer (112).
b. Remove flange (85).
23.
REMOVE OUTPUT GEARS (117) AND (120).
20.
REMOVE BEARING HOUSING (88).
a. Remove sleeve bushing (113), four retainers and
rollers (115), two rings (116) and gears (117)and
a. Remove four capscrews (86) and lockwashers
(120).
(87). Discard lockwashers (87).
b. Remove gear hub (118) and sleeve bearing
b. Remove bearing housing (88).
(119).
c. Remove cup (110) and preformed packings (89)
24.
DISASSEMBLE REAR AXLE DISCONNECT
and (90). Discard packings (89) and (90).
(94).
d. If necessary, remove seal (91).
a. Remove plug (97) and setscrew (98).
21.
REMOVE
REAR
AXLE
DISCONNECT
b. Remove shift rail (100) with spring (101) and ball
HOUSING (94).
bearing (102).
a. Remove four capscrews (92) and lockwashers
c. Remove seals (103) and (104). Discard seals
(93). Discard lockwashers (93).
(103) and (104).
b. Remove housing (94) pulling it straight out.
d. Remove retaining ring (105) and gearshaft (108)
with bearing (106).
c. Remove shims (95). Note number and size of
shims (95).
e. Remove bearing (106), hub shaft (109) and fork
d. Remove and discard preformed packing (96).
shift (99).
22. REMOVE OUTPUT SHAFT (114).
NOTE
a. Support gears (117) and (120).
Do not mix clutch discs among the
clutch packs.
b. Using press, push straight shaft (114) from front
through gears (117) and (120).
7-32
