TM 5-3810-306-34
CAUTION
23. INSTALL BUSHINGS (14).
Do not damage piston rings.
a. Press bushings (14) into transmission cover (5).
e. Install eight capscrews (22), (26) and (29).
b. Install sleeve (13), two bolts (12) and new
f.
Tighten capscrews 37-41 ft-lbs (49-55 Nm ).
24. INSTALL TUBES (7) AND (11).
g. Install pipe plug (28).
CAUTION
28. INSTALL FLANGE (33).
Sleeves (15) and tubes (7) and (11)
a. Install flange (33) with new preformed packing
(32), washer (31) and nut (30).
must be installed together, lightly
tapping sleeves (15) to seat.
b. Torque nut (30) to 150-200 ft-lbs (200-265 Nm
).
a. Install new preformed packings (6), sleeves (15)
29. INSTALL ADAPTER PLATE (34c).
and tubes (7) and (11).
a. If removed, install new packing (34n), elbow
(34r) and switch (34g) in fitting (34m).
bolts (10).
b. Position adapter plate (34c) on cover (5).
25. INSTALL BEARING (3).
c.
Install new packing (34p) and fitting (34m).
a. Install bearing (3) and retaining rings (2).
d. Install plug (341).
b. Press new seal (1) into transmission cover (5).
e. Install new packings (34k) and (34j), and fitting
26. INSTALL GEARSHAFT (20) INTO TRANSMISSION
(34i).
COVER (5).
f.
Install new packings (34h) and (34g), and fittings
27. INSTALL TRANSMISSION COVER (5).
(34g).
a. Install front bearing special ring (33).
g. Install new packing (34e) and fitting (34d).
b. Support transmission cover (5) with overhead
hoist.
c.
Using snap ring pliers, hold special ring (34)
END OF TASK
open.
d. Position transmission cover (5) to transmission
housing.
7-56