TM 5-3810-306-34
a. Apply silicone gasket material (RTV) to
NOTE
cover flange on spider to hub mating
surface.
The set screws are Dri-Loc fasteners.
Refer to General Procedures for use
b. Start spider and pinion assembly, aligning
of these.
teeth of spur gear (13) and gear teeth (8).
Line up match-marks.
j. Install set screw (17) into spider and shaft
(15). Torque screw 15 to 25 ft-lbs (20-33
c. Align hub holes with spider holes and push
Nm).
spider assembly against hub.
d. Install thirty washers (34) and capscrews
(18). Torque capscrews (18) to 85-115 ft-
lbs (113-153 Nm).
9. FILL
WHEEL
END
ASSEMBLIES
WITH
MULTIPURPOSE GEAR OIL MIL-L-2105.
a. Turn hub and drum assembly so the
DRAIN/FILL plug (1) 900 from bottom.
k. Repeat steps d thru j for each of two
remaining spur gears (13) and shafts (15).
b. Fill each housing until lubricant appears at
drain plug hole. Replace all plugs and
8. INSTALL SPIDER.
tighten them securely.
WARNING
10. ADJUST BRAKES.
(REFER TO TM 5-3810306-
20.)
Eye contact with these silicone RTV
materials may cause irritation. If eye
11. UNCAGE SPRING IN AIR BRAKE CHAMBER.
contact takes place, flush the eyes
(REFER TO TM 5-3810-306-20.)
with water for 15 minutes and have
the eyes examined by a doctor.
12. INSTALL WHEEL AND TIRE
ASSEMBLIES.
(REFER TO TM 5-3810-306-20.)
WARNING
13. TEST FOR PROPER OPERATION.
Minor concentrations of acetic acid
vapor may be produced during
END OF TASK
application.
Adequate ventilation
should be provided when silicone
RTV is applied in confined areas.
8-60
