TM 5-3810-306-34
b. Check ring seals (8) for wear and replace if
NOTE
necessary.
Gears are a matched set, therefore
5. REMOVE GEAR HOUSING (5).
both gears must be replaced even if
only one was found damaged.
CAUTION
CAUTION
If gear housing (5) will not lift off, pry
it off using care to avoid damaging
Avoid distorting thrust plates.
machined surfaces.
b. If thrust plates (9) remained in gear housing (5),
a. Remove integral shaft and gear (11), gear (10),
tap them out with a wooden hammer handle.
and gear housing (5) from shaft end housing
(16).
Keep gears together as they are a
c. Remove and discard packings (14) from grooves
matched set.
in housing (5).
13-3