TM 5-3810-306-34
b. Insert keyed end of integral shaft and gear (11)
d. Slide gear housing (5) over gears and tap with a soft
into special steel sleeve (Item 5, Appendix C).
hammer until housing rests tightly against the shaft end
Lightly grease driveshaft and sleeve. Insert shaft
cover (16).
with sleeve into shaft end cover with twisting
motion. Be careful not to damage shaft seal
NOTE
(17). Push down carefully until gear rests
against thrust plate (9). Remove steel sleeve.
Oil the gears to provide initial
lubrication when the motor is started.
c. Install drive gear (10) into the shaft end cover
roller bearing bores.
8. INSTALL PORT END COVER (4).
CAUTION
CAUTION
Avoid pinching the gasket seal (14).
Avoid pinching gasket seal (14).
CAUTION
CAUTION
Ensure index marks are properly
Ensure index marks are properly
aligned.
aligned.
13-8
