TM 5-3810-306-34
5. INSTALL BEARINGS (6).
d. Cut four pocket seals for each thrust plates (9)
a. Replace any bearings that have been removed
approximately 0.25-in. (6.35 mm) long from
from shaft end cover (16) and port end cover (4).
pocket seal strip. Insert one pocket seal into
Install bearings with an arbor press.
each slot in thrust plate. Push each pocket seal
all the way in so that they touch roller bearings.
6. INSTALL THRUST PLATES (9).
Tap thrust plates down firmly against machined
surface with a soft hammer. Using a sharp razor
a. Cut two pocket seals for each thrust plate 0.219
blade, trim exposed end of pocket seal square
in. (5.56 mm] long from pocket seal strip.
and flush with thrust plate.
b. Place a small amount of heavy grease into two
7. INSTALL GEAR HOUSING (5).
middle slots in open face of thrust plates (9) and
insert pocket seals (13).
a. Grease the new packings (14) and install them
into grooves in both sides of gear housing (5).
c. With pocket seals down, place thrust plates (9)
over bearings (6) in shaft end cover (16) and
port end cover (4). Tap thrust plates with a soft
hammer to about 0.031-in. (0.794 mm) from
machined surface.
13-7
