TM 5-3810-306-34
ADJUSTMENT:
1. TURN SCREW (POTENTIOMETER AXLE) IN
CENTER OF LARGE NYLON GEAR (INSIDE
LENGTH/ANGLE CABLE REEL ASSEMBLY (16)
COUNTERCLOCKWISE UNTIL IT STOPS. DO
NOT FORCE SCREW.
2. CONNECT NEGATIVE BATTERY CABLE AT
SHUNT. (REFER TO PAGE TM 5-3810-306-20.)
3. START CRANE AND RAISE BOOM TO 0
DEGREES. PLACE A LEVEL ON TOP OF BOOM
BASE SECTION AND ON ANGLE SENSOR INSIDE
LENGTH/ANGLE CABLE REEL ASSEMBLY (16).
4. LOOSEN SOCKET HEAD SCREWS ON ANGLE
SENSOR AND ADJUST ANGLE SENSOR TO
SAME ANGLE AS BOOM BASE SECTION.
5. LUBRICATE HEX HEAD SCREWS (9) WITH
OE/HDO ENGINE OIL.
6. INSTALL COVER (11), WASHERS (10) AND HEX
HEAD SCREWS (9).
7. COMPARE LOAD MONITOR INDICATOR DISPLAY
TO BOOM LENGTH AND ANGLE TO CONFIRM
PROPER FUNCTION OF SYSTEM.
END OF TASK
14-14
