TM 5-3810-306-34
5. INSTALL GEROTOR (5).
b. Install capscrews (1) and sealwashers (2) in end
a. Install 2.875 in. (7.3 cm) diameter seal (6) in
cap. Pretighten all screws to 40 in-lbs (4 Nm).
gerotor seal groove.
Check to ensure seals are seated properly in
grooves. Tighten capscrews to final torque of
b. Carefully place gerotor (5) on wear plate (9), seal
275 to 300 in-lbs (30-33 Nm) following the
side toward the wear plate. Install the gerotor
sequence shown.
with any tooth aligned with timing mark on drive.
c. Turn gerotor (5) to line up holes for capscrews,
be careful not to disengage star from drive.
d. With orientation shown in Motor Timing figure,
output shaft (17) will rotate as shown with the
ports pressurized as shown.
7. INSTALL SWING MOTOR.
(REFER TO TM 5-
3810-306-20.)
6. INSTALL END CAP (3).
a. Install 2.875 in. (7.3 cm) diameter seal (4) in
end cap (3), then carefully place end cap on
gerotor.
END OF TASK
15-142
