TM 9-3950-253-13&P
0007
PLACE LIFT FRAME ON GROUND - Continued
17.
With engine at idling speed, set MODE switch (Figure 25, Item 1) to OFF (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P).
Figure 25. Mode Switch at OFF.
END OF TASK
PICK UP LIFT FRAME FROM GROUND
1.
Verify these conditions exist:
a.
Lift mechanism in home position (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
b.
Vehicle in neutral gear and parking brake applied (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P).
c.
MODE switch set to OFF (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
d.
Stowage toggle switch set to OFF position (WP 0004).
e.
Slider beds in container configuration (WP 0006).
f.
Container locking pins on lift frame in stowed position (Release Locking Pins in this work package).
g.
NO TRANS light off (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
h.
HEMTT only: PTO switch in ON position (TM 9-2320-326-14&P).
WARNING
Use a ground guide at all times when unloading/loading lift frame.
Use extreme caution if high wind conditions exist while unloading/loading lift frame.
With assistance, attach guide straps to the legs of the lift frame to stabilize the lift
frame during the unloading/loading procedure.
DO NOT stand directly behind lift frame during unloading/loading.
Failure to follow these warnings may result in injury or death to personnel. Seek
medical attention in the event of an injury.
2.
Position rear of vehicle (Figure 26, Item 1) so it is in front of (i.e., with hook-bar projecting toward vehicle)
and parallel with lift frame (Figure 26, Item 2), and is approximately 5 ft (1.5 m) from lift frame.
03/15/2011Rel(1.10)root(opusualwp)wpno(O582007)