TM 9-3950-253-13&P
OPERATOR MAINTENANCE
SLIDER BED CONFIGURATION
INITIAL SETUP:
References
Equipment Condition (cont.)
TM 9-2320-326-14&P
Stowage switch set to OFF position (WP 0004)
TM 9-2320-364-14&P
NO TRANS light off (PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P)
Vehicle in neutral gear with parking brake applied
Equipment Condition
(PLS: TM 9-2320-364-14&P,
Hook arm in home position
HEMTT: TM 9-2320-326-14&P)
(PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P)
MODE switch set to OFF position
(PLS: TM 9-2320-364-14&P,
HEMTT: TM 9-2320-326-14&P)
INTRODUCTION
The rear slider assembly has two configurations: container and flatrack.
1.
In container configuration, the front slider beds and twistlock assemblies are positioned to be on the same
horizontal plane as the rear slider beds.
2.
In flatrack configuration, the front slider beds are at an angle to the rear slider beds and on the same
horizontal plane as the truck bed. On the HEMTT only, the rear twistlocks are folded under rear slider
beds to comply with departure angle requirements.
Figure 1. Slider Bed Configuration.
03/15/2011Rel(1.10)root(opusualwp)wpno(O582006)