TM 9-3950-253-13&P
0006
CONVERT SLIDER BEDS FROM CONTAINER TO FLATRACK CONFIGURATION
Front Slider Bed Configuration
WARNING
During these adjustments, you are required to work at the rear of the vehicle where
there are several protruding parts. Use extreme caution and wear a hard hat.
Pivot weight of front slider bed is 45 lb (20 kg). Use extreme caution while
changing the configuration of front slider beds.
After releasing locking pin, move hands out of the way to avoid pinching.
Failure to follow these warnings may result in injury to personnel. Seek medical
attention in the event of an injury.
1.
From rear of vehicle, on left side, push front slider bed (Figure 4, Item 1) slightly to relieve tension on locking
pin (Figure 4, Item 2) and push down on locking pin, keeping it from engaging with front slider bed.
2.
Allow front slider bed (Figure 4, Item 1) to pivot downward until it reaches a horizontal position and locking
pin (Figure 4, Item 2) engages into locked position.
Figure 4. Front Slider Bed (Container to Flatrack).
03/15/2011Rel(1.10)root(opusualwp)wpno(O582006)