TM 9-3950-253-13&P
0006
CONVERT SLIDER BEDS FROM CONTAINER TO FLATRACK CONFIGURATION - Continued
Rear Twistock Configuration
WARNING
During this procedure, the twistlock assembly will be allowed to swing free unless it is
manually supported. Ensure no personnel are standing in the path of the twistlock
assembly. Failure to follow this warning may result in injury to personnel. Seek medical
attention in the event of an injury.
NOTE
Rear twistlocks require adjustment on HEMTT only.
Perform steps 1 through 7 for both right and left sides.
Ensure anvil is in stowed position (WP 0008).
1.
While supporting twistlock (Figure 5, Item 7) remove locking pin (Figure 5, Item 5) from rear slider bed
(Figure 5, Item 3).
2.
Rotate twistlock (Figure 5, Item 7) up until locking tube (Figure 5, Item 4) aligns with upper locking hole in
rear slider bed (Figure 5, Item 3) and insert locking pin (Figure 5, Item 5).
3.
Remove R clip (Figure 5, Item 2) from rear slider bed (Figure 5, Item 3).
4.
While supporting twistlock housing (Figure 5, Item 6), remove locking pin (Figure 5, Item 1).
5.
Rotate anvil (Figure 5, Item 8) until aligned with opening in twistlock housing (Figure 5, Item 6).
6.
Rotate twistlock housing (Figure 5, Item 6) up until it engages with twistlock (Figure 5, Item 7) and install
locking pin (Figure 5, Item 1).
7.
Install R clip (Figure 5, Item 2) in rear slider bed (Figure 5, Item 3).
0006-7
03/15/2011Rel(1.10)root(opusualwp)wpno(O582006)