TM 9-3950-253-13&P
0006
CONVERT SLIDER BEDS FROM FLATRACK TO CONTAINER CONFIGURATION
Front Slider Bed Configuration
NOTE
Front slider bed container configuration is the same for both PLS and HEMTT.
Rear twistlocks on HEMTT require adjustment for container configuration.
1.
Position vehicle as if loading a flatrack (PLS: TM 9-2320-364-14&P, HEMTT: TM 9-2320-326-14&P).
WARNING
During these adjustments, you are required to work at rear of vehicle where there
are several protruding parts. Use extreme caution and wear a hard hat.
Pivot weight of front slider bed is 45 lb (20 kg). Use extreme caution while
changing configuration of front roller beds.
Failure to follow these warnings may result in injury to personnel. Seek medical
attention in the event of an injury.
NOTE
Perform steps 2 and 3 for both right and left sides.
2.
From rear of vehicle, on left side, raise front slider bed (Figure 2, Item 1) slightly to relieve tension on locking
pin (Figure 2, Item 3).
3.
Continue to pivot front slider bed (Figure 2, Item 1) until it aligns with rear slider bed (Figure 2, Item 2) and
locking pin engages into locked position.
0006-2
03/15/2011Rel(1.10)root(opusualwp)wpno(O582006)