TM 9-3950-253-13&P
0006
CONVERT SLIDER BEDS FROM FLATRACK TO CONTAINER CONFIGURATION - Continued
Rear Twistlock Configuration
WARNING
During this procedure, the twistlock assembly will be allowed to swing free unless it is
manually supported. Ensure no personnel are standing in path of twistlock assembly.
Failure to follow this warning may result in injury to personnel. Seek medical attention in
the event of an injury.
NOTE
Rear twistlocks require adjustment on HEMTT only.
Perform steps 1 through 7 for both right and left sides.
Ensure anvil is in stowed position (WP 0008).
1.
Remove R clip (Figure 3, Item 2) from rear slider bed (Figure 3, Item 3).
2.
While supporting twistlock housing (Figure 3, Item 6), remove locking pin (Figure 3, Item 1).
3.
Rotate twistlock housing (Figure 3, Item 6) out until aligned with rear slider bed (Figure 3, Item 3) and install
locking pin (Figure 3, Item 1) in rear slider bed.
4.
Install R clip (Figure 3, Item 2) in rear slider bed (Figure 3, Item 3).
5.
While supporting twistlock (Figure 3, Item 7), remove twistlock securing pin (Figure 3, Item 5) from upper
locking hole in rear slider bed (Figure 3, Item 3).
6.
Rotate twistlock (Figure 3, Item 7) until locking tube (Figure 3, Item 4) aligns with lower locking hole in rear
slider bed (Figure 3, Item 3) and install locking pin (Figure 3, Item 5).
7.
Verify all retaining pins are securely in place.
0006-4
03/15/2011Rel(1.10)root(opusualwp)wpno(O582006)