TM 9-3950-253-13&P
0009
RAISE A PARTIALLY SUBMERGED CONTAINER - Continued
Attaching Lower Guides
WARNING
During these adjustments, personnel are required to work outside the vehicle where there
are several projecting parts, and personnel are required to bend down. Take care when
bending and straightening. A hard hat is required. Failure to follow this warning may result
in injury to personnel. Seek medical attention in the event of an injury.
NOTE
If misalignment is too great, lower section of lift frame may need to be repositioned
by either lowering (unloading) or raising (loading) hook.
Perform steps 1 through 5 for both right and left sides.
1.
Check that hole in each lower guide (Figure 15, Item 3) is aligned with aperture in side of corner casting of
container (Figure 15, Item 2). Small amounts of misalignment may be acceptable.
2.
Release anti-loose fastener (Figure 15, Item 4) that secures lower locking plate (Figure 15, Item 1).
3.
Pull out locking plate (Figure 15, Item 1) and rotate it 90 to align locking pin with locking hole in lower guide
(Figure 15, Item 3).
4.
Push locking plate (Figure 15, Item 1) to fully insert locking pin through locking hole in lower guide
(Figure 15, Item 3) and into corner casting.
5.
Lock anti-loose fastener (Figure 15, Item 4) to hold locking plate (Figure 15, Item 1) in position.
Figure 15. Lock Lower Guides.
03/15/2011Rel(1.10)root(opunuwp)wpno(O582009)