TM 9-3950-253-13&P
0063
REMOVAL
WARNING
During these procedures, the operator will be required to climb on and around the
vehicle. Be sure to wear suitable footwear, that no surfaces are slippery, wear
suitable gloves and hard hat, and maintain three points of contact to the vehicle.
Use extreme caution when removing pneumatic hoses. Wear protective goggles or
face shield.
Failure to follow these warnings may result in injury or death to personnel. Seek
medical attention in the event of an injury.
NOTE
Note position of actuator to aid in installation.
1.
Remove bolt (Figure 1, Item 1), yoke (Figure 1, Item 2), and nut (Figure 1, Item 3) from capture plate
(Figure 1, Item 7).
2.
Remove bolt (Figure 1, Item 4), end washer (Figure 1, Item 5), pivot pin (Figure 1, Item 6), and capture plate
(Figure 1, Item 7) from latch assembly (Figure 1, Item 8).
3.
Remove yoke (Figure 1, Item 2), jam nut (Figure 1, Item 17), and boot (Figure 1, Item 16) from actuator
(Figure 1, Item 11).
4.
Remove fitting (Figure 1, Item 9) and washer (Figure 1, Item 10) from actuator (Figure 1, Item 11).
5.
Remove two locknuts (Figure 1, Item 15), washers (Figure 1, Item 14), bracket (Figure 1, Item 13), and
actuator (Figure 1, Item 11) from mounting plate Figure 1, Item 12). Discard locknuts.
0063-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582062)