TM 9-3950-253-13&P
0063
INSTALLATION
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear, that no surfaces are slippery, wear suitable gloves and
hard hat, and maintain three points of contact to the vehicle. Failure to follow this warning
may result in injury to personnel. Seek medical attention in the event of an injury.
1.
Install actuator (Figure 2, Item 11), bracket (Figure 2, Item 13), two washers (Figure 2, Item 14), and new
locknuts (Figure 2, Item 15) on mounting plate (Figure 2, Item 12).
2.
Install washer (Figure 2, Item 10), and fitting (Figure 2, Item 9) on actuator (Figure 2, Item 11).
3.
Install capture plate (Figure 2, Item 7), pivot pin (Figure 2, Item 6), end washer (Figure 2, Item 5), and bolt
(Figure 2, Item 4) on latch assembly (Figure 2, Item 8).
4.
Install boot (Figure 2, Item 16), jam nut (Figure 2, Item 17), and yoke (Figure 2, Item 2) on actuator
(Figure 2, Item 11).
5.
Adjust placement of yoke (Figure 2, Item 2) on actuator (Figure 2, Item 11) to align yoke with boss on
capture plate (Figure 2, Item 7). Tighten jam nut when aligned.
NOTE
Finger tighten bolt on installation. Tighten nut to capture plate when aligned.
6.
Install bolt (Figure 2, Item 1), yoke (Figure 2, Item 2), and nut (Figure 2, Item 3) on capture plate (Figure 2,
Item 7). Adjust depth of bolt to vertically align yoke on actuator.
0063-4
03/15/2011Rel(1.10)root(maintwp)wpno(M582062)