TM 9-3950-253-13&P
0064
INSTALLATION
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear, ensure no surfaces are slippery, wear suitable gloves
and hard hat and maintain three points of contact to the vehicle. Failure to follow this
warning may result in injury to personnel. Seek medical attention in the event of an injury.
NOTE
Install hoses as tagged during removal.
Remove caps from hoses and fittings prior to installation.
1.
Install stowage cylinder (Figure 1, Item 5), cylinder bearing (Figure 1, Item 6), and snap ring pin (Figure 1,
Item 2) on stowage assembly (Figure 1, Item 1).
2.
Install stowage cylinder (Figure 1, Item 5), retaining pin (Figure 1, Item 3), and snap ring pin (Figure 1, Item
4) on stowage assembly (Figure 1, Item 1).
3.
Install two hydraulic hoses (Figure 1, Item 7) on stowage cylinder (Figure 1, Item 5).
END OF TASK
FOLLOW-ON MAINTENANCE
1.
Stow lift frame on vehicle (WP 0007).
NOTE
When stowing lift frame, if lift frame lower securing tube is positioned above and to the
front of stowage rack lock bracket, the cylinder rod end may need adjustment. This
adjustment will move the stop position of the capture frame rearward, causing the lift frame
securing tube to move rearward and downward. The cylinder rod end may be adjusted to a
maximum of 3/8 in. out from original position. A 1/8 in. adjustment in the cylinder rod end
will move the lift frame securing tube approximately 1/4 in.
2.
Unload lift frame and place on ground (WP 0007).
0064-3
03/15/2011Rel(1.10)root(maintwp)wpno(M582063)