TM 9-3950-253-13&P
0065
INSTALLATION
1.
Install two bearings (Figure 2, Item 9) in stowage guide (Figure 2, Item 1).
WARNING
Use extreme caution when handling heavy parts. Provide adequate support and use
assistance during procedure. Ensure any lifting device used is in good condition and of
suitable load capacity. Keep clear of heavy parts supported only by lifting device. Failure to
follow this warning may result in injury or death to personnel. Seek medical attention in the
event of an injury.
NOTE
Stowage guide weighs 107 lb (49 kg).
2.
Attach sling and lifting device to stowage guide (Figure 2, Item 1).
3.
Use lifting device to install stowage guide (Figure 2, Item 1) on stowage assembly (Figure 2, Item 7).
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear and that no surfaces are slippery. Wear suitable gloves
and hard hat. Failure to follow this warning may result in injury to personnel. Seek medical
attention in the event of an injury.
4.
Apply grease to two pivot pins (Figure 2, Item 4).
5.
Install two pivot pins (Figure 2, Item 4) and new spring pins (Figure 2, Item 6) in stowage guide (Figure 2,
Item 1).
6.
Install two grease fittings (Figure 2, Item 5) on pivot pins (Figure 2, Item 4).
7.
Apply grease to pivot pin (Figure 2, Item 2).
8.
Install stowage cylinder (Figure 2, Item 8), pivot pin (Figure 2, Item 2), and snap ring pin (Figure 2, Item 3)
on stowage guide (Figure 2, Item 1).
0065-4
03/15/2011Rel(1.10)root(maintwp)wpno(M582064)