TM 9-3950-253-13&P
0066
REMOVAL
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear and that no surfaces are slippery. Wear suitable gloves
and hard hat. Failure to follow this warning may result in injury to personnel. Seek medical
attention in the event of an injury.
1.
Remove three locknuts (Figure 1, Item 19), washers (Figure 1, Item 20), bolts (Figure 1, Item 1), washers
(Figure 1, Item 2), and sensor cover (Figure 1, Item 3) from stowage assembly (Figure 1, Item 21). Discard
locknuts.
NOTE
Note placement of sensor arm on sensor linkage to aid in installation.
2.
Remove locknut (Figure 1, Item 8), washer (Figure 1, Item 7), bolt (Figure 1, Item 15), washer (Figure 1,
Item 14), and sensor arm (Figure 1, Item 6) from sensor linkage (Figure 1, Item 13). Discard locknut.
3.
Remove locknut (Figure 1, Item 5), washer (Figure 1, Item 4), and sensor arm (Figure 1, Item 6) from
stowage guide (Figure 1, Item 22). Discard locknut.
4.
Remove two locknuts (Figure 1, Item 10), washers (Figure 1, Item 11), bolts (Figure 1, Item 18), washers
(Figure 1, Item 17), and angle sensor (Figure 1, Item 9) from sensor bracket (Figure 1, Item 16). Discard
locknuts.
5.
Disconnect harness (Figure 1, Item 12) from angle sensor (Figure 1, Item 9).
0066-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582065)