TM 9-3950-253-13&P
0066
INSTALLATION
WARNING
During these procedures, the operator will be required to climb on and around the vehicle.
Be sure to wear suitable footwear and that no surfaces are slippery. Wear suitable gloves
and hard hat. Failure to follow this warning may result in injury to personnel. Seek medical
attention in the event of an injury.
1.
Connect harness (Figure 2, Item 12) to angle sensor (Figure 2, Item 9).
2.
Install angle sensor (Figure 2, Item 9), two washers (Figure 2, Item 17), bolts (Figure 2, Item 18), washers
(Figure 2, Item 11), and new locknuts (Figure 2, Item 10) on sensor bracket (Figure 2, Item 16).
NOTE
Install sensor arm on sensor linkage as noted during removal.
Leave locknuts on sensor arm loose enough to allow movement of arm.
3.
Install sensor arm (Figure 2, Item 6), washer (Figure 2, Item 4), and new locknut (Figure 2, Item 5) on
stowage guide (Figure 2, Item 22).
4.
Install bolt (Figure 2, Item 15), washer (Figure 2, Item 14), sensor arm (Figure 2, Item 6), washer (Figure 2,
Item 7), and new locknut (Figure 2, Item 8) on sensor linkage (Figure 2, Item 13).
5.
Install sensor cover (Figure 2, Item 3), three washers (Figure 2, Item 2), bolts (Figure 2, Item 1), washers
(Figure 2, Item 20), and new locknuts (Figure 2, Item 19) on stowage assembly (Figure 2, Item 21).
0066-4
03/15/2011Rel(1.10)root(maintwp)wpno(M582065)
