TM 9-3950-253-13&P
0071
REMOVAL
WARNING
Lifting cables, chains, hooks, and slings used for lifting must be in good condition
and of suitable capacity.
Improper use of lifting device and improper attachment of cables may cause injury
to personnel and damage to equipment. Observe all standard rules of safety.
Use extreme caution when handling heavy parts. Provide adequate support and
use assistance during procedure. Ensure any lifting device used is in good
condition and of suitable load capacity. Keep clear of heavy parts supported only
by lifting device.
Lift frame must be firmly positioned on solid, level ground.
Failure to follow these warnings may result in injury or death to personnel. Seek
medical attention in the event of an injury.
NOTE
Upper lock assembly weighs 90 lb (41 kg).
Perform these procedures for both right and left sides.
Note placement of upper lock on lift frame to aid in installation.
1.
Attach sling and lifting device to upper lock assembly (Figure 1, Item 5).
2.
Use lifting device to remove slack from sling.
3.
Remove two locknuts (Figure 1, Item 2), washers (Figure 1, Item 3), and stop block (Figure 1, Item 4) from
lift frame (Figure 1, Item 1). Discard locknuts.
4.
Use lifting device to remove upper lock assembly (Figure 1, Item 5) from lift frame (Figure 1, Item 1).
5.
Remove two locknuts (Figure 1, Item 6), washers (Figure 1, Item 7), bolts (Figure 1, Item 10), washers
(Figure 1, Item 9), and plate (Figure 1, Item 8) from lift frame (Figure 1, Item 1). Discard locknuts.
0071-2
03/15/2011Rel(1.10)root(maintwp)wpno(M582070)