TM 10-3930-641-20
(Sheet 2 of 5)
TRANSMISSION CONTROL LINKAGE ADJUSTMENT (CONT)
REMARKS
ACTION
LOCATION/ITEM
Stop (1) must move lever (4) to NEUTRAL when steer-
1. Stop (1)
Check stop for proper adjustment. If stop is
ing column is in stored position.
out of adjustment:
Put control lever in NEUTRAL.
a.
b. Move steering column (3) forward to stored
position.
Loosen capscrews (2).
c.
d. Move stop until end just touches lever
assembly (4).
Tighten capscrews (2).
e.
I
Adjust:
2. Speed control linkage (Located on
steering hydraulic controls. See
Remove cap screws (1) and lockwashers
a.
(2).
b. Loosen nut (3) from cable threads (5) and
slide washer (11) and seal (10) back.
Turn bracket (4) off threads (5).
c.
d. Lift pins (6) and yoke (7) out of slot in
speed selection spool (8).
Go on to Sheet 3
2-408
