TM 10-3930-641-34-1
FUEL INJECTION NOZZLE REMOVAL AND INSTALLATION
(Sheet 4 of 4)
LOCATION/ITEM
ACTION
REMARKS
2. Seal and bushing (7)
a. Install in pump housing bore.
b. Bushing should turn into threads of housing
with fingers until flush with housing, if
pump is in correct position.
c. Tighten bushing to torque of 140-160 lb. ft.
(190-218 N.m) with 8S4613 wrench.
3. Washer
Install on bushing (7).
4. Fuel lines
Connect to pumps and torque to 25-35 lb. ft.
(32-48 N-m).
5. Governor control link (3)
Install.
6. Injection pumps
Check for correct installation with engine
stopped.
CAUTION
If one or more of injection pumps has been in-
stalled wrong, then damage to engine is possi-
ble. Precautions to shut down engine should be
taken immediately.
7. Timing pin, 5P4185
Remove and install plug (2).
TA098994
END
3-35
