TM 10-3930-641-34-2
TRANSMISSION ASSEMBLY (CONT)
(Sheet 25 of 31)
LOCATION/ITEM
ACTION
REMARKS
85.
Manifold assembly (cont)
d. Remove the two capscrews that are aligned
with the openings.
e. Install two threaded rods (3/8"-16NC
x 8") into the two capscrew holes as
shown at right.
f.
Install two large flat washers and nuts on
the rods.
NOTE
Before the nuts are tightened, be sure the
notch in the bearing aligns with the dowel
in the shaft assembly.
86
Sun gear (80)
Install over shaft.
87.
Snap ring (81)
Install in groove above sun gear on shaft
assembly.
NOTE
It may be necessary to tighten nuts further
(Step 85 f., above) to expose groove.
TA099317
Go on to Sheet 26
4-112
