TM 10-3930-641-34-2
TRANSMISSION ASSEMBLY (CONTD)
(Sheet 30 of 31)
LOCATION/ITEM
ACTION
REMARKS
104. Capscrews (79) and washers (119)
Install and tighten to a torque of 65-851b. ft.
(88-116 N-m).
105. Tooling (sleeve, retainer,
Remove from end of shaft assembly
capscrew)
(See Step 37).
106. Capscrew (6) and retainer plate
Install in end of shaft assembly.
(7)
107. Pistons
Check for correct operation:
a. Blow air under pressure of 100-150 psi
(690-1035 kPa) into each of the five oil
passages as shown.
b. Check that each piston will move at least
.12 to .15 in. (3.0 to 6.4 mm).
c.
If any of the pistons do not move the
correct distance, insert a small amount of
clean oil into that passage and recheck
with compressed air.
d. If any or all pistons still do not operate
correctly, transmission must be dis-
assembled to check condition of pistons
Go on to Sheet 31
and seals.
Go on to Sheet 31
4-117