TM 10-3930-641-34-2
TRANSFER GEAR ASSEMBLY (OUTPUT) ASSEMBLY (CONT)
(Sheet 6 of 9)
LOCATION/ITEM
ACTION
REMARKS
18.
Cage (79)
a. Install in gear case.
NOTE
For now, do not install shims (73) or pre-
formed packing (72) behind cage.
b.
Secure cage with capscrews (1) and
washers (16).
c.
Using a feeler gage, measure gap between
cage (79) and gear case.
d.
Remove cage and install correct thickness
of shims (73) to take up gap measured in
c above.
e.
Install cage (and capscrews (1) and install
dial indicator to gear case as shown).
NOTE
Indicator stem should contact top surface of
gear (71).
f.
Attach wire to top of gear (71) and move
gear up and down to check end play.
g.
Remove or install shims until end play is
.002-.006 in. (0.05-0.15 mm).
h.
When correct thickness of shims is ob-
tained, install preformed packing (72)
behind cage.
i.
Install cage and secure with the capscrews
(1) and washers (16).
TA099349
Go on to Sheet 7
4-151
