TM 10-3930-641-34-2
TRANSFER GEAR ASSEMBLY (OUTPUT) ASSEMBLY (CONT)
(Sheet 7 of 9)
LOCATION/ITEM
ACTION
REMARKS
19.
Preformed packing (76)
Install on cage (79).
20.
Cover (74)
Install on cage (79).
21.
Bearing cup (8)
Lower temperature of cup and install in cage
(3).
22.
Cage (3)
a.
Install in gear case.
NOTE
For now, do not install shims (4) behind cage.
b.
Secure cage with capscrews (1).
c.
Using a feeler gage, measure gap between
cage (3) and gear case.
d.
Remove cage and install correct thickness
of shims (4) to take up gap measured in c
above.
e.
Install cage (and capscrews (1)) and install
dial indicator to gear case as shown.
NOTE
Indicator stem should contact top surface of
gear (37).
f.
Attach wire to top of gear and move gear
up and down to check end play.
g.
Remove or install shims until end play is
.002-.006 in. (0.05-0.15 mm).
h.
When correct thickness of shims is ob-
tained, install locks (2) under capscrews
(1).
TA099350
Go on to Sheet 8
4-152
