TM 10-3930-641-34-2
BEARING CAGE ADJUSTMENT
(Sheet 3 of 4)
LOCATION/ITEM
ACTION
REMARKS
6.
Seal (5)
Install in cage (4). Put a small amount of
grease on seal.
7.
Shims (3)
Install enough shims so their thickness is .002.
in. (0.05 mm) less than the gap in Step 5,
Section e.
8.
Retainer (2)
Install with capscrews (1) and washers.
Tighten capscrews (1) to a torque of 65 to
85 lb. ft. (86 to 114 N-m).
9.
Seal (12)
a. Put small amount of grease on the lip.
b. Install.
10.
Yoke assembly (9)
Install on shaft.
11.
Retainer (10)
Install on shaft without seal (11) and shims
(14).
12.
Capscrews (13)
a. Install without washers and tighten to a
torque of 50 to 70 lb. ft. (66 to 94 N-m).
TA099448
Go on to Sheet 4
4-325