TM 10-3930-641-34-2
BEARING CAGE ADJUSTMENT
(Sheet 2 of 4)
LOCATION/ITEM
ACTION
REMARKS
1.
Seal (7)
a. Install in bearing cage (4).
b. Grease seal with a small amount of grease.
c. Put cage (4) in position on frame.
2.
Capscrews (8)
Install, with washers and nuts.
3.
Bearing (6)
Install in cage (4).
4.
Retainer (2)
Put into position on cage (4) without seal (5)
and shims (3).
5.
Capscrews (1)
a. Install three without washers and an equal
distance apart.
b. Tighten evenly to a torque of 65 to 85 lb.
ft. (86 to 114 N-m).
c. Loosen.
d. Tighten again to finger tight.
e. Measure gap between retainer (2) and
cage (4) with a feeler gage. Record the
distance.
TA099447
Go on to Sheet 3
4-324