TM 10-3930-641-34-2
DRIVE SHAFTS DISASSEMBLY / ASSEMBLY (CONT)
(Sheet 13 of 15)
LOCATION/ITEM
ACTION
REMARKS
22.
Preformed packing (26)
Install in yoke.
23.
Shim(s) (27)
a. Recall thickness measured in Step 21.
b. Install shim(s) to be from .002 to .004
in. (0.05 to 0.11 mm) thinner than the
thickness measured in Step 21.
c.
Place this shim pack on end of front shaft.
Align holes.
24.
Retainer (28)
Place over shim pack. Align holes.
25.
Three capscrews (23) and washers
Install. Tighten to a torque of 90 to 110 lb. ft.
(15)
(122 to 149 Nm).
TA099444
Go on to Sheet 14
4-320