TM 10-3930-641-34-2
DRIVE SHAFTS DISASSEMBLY / ASSEMBLY (CONT)
(Sheet 11 of 15)
LOCATION/ITEM
ACTION
REMARKS
11. Clearance between retainer (22) and
a. Measure clearance with feeier gage.
cage (16)
b. Record this measurement.
12. Bearing cage retainer (22)
Remove from cage.
13. Seal (13)
a. Install in retainer with suitable seal driver.
Seal must contact counterbore in retainer.
Seal lip must face away from retainer.
b. Coat lip of seal with GAA grease.
14. Preformed packing (19)
Install in cage.
15. Shim(s) (21) and (20)
a. Recall clearance measured in Step 11.
b. Add shim(s) to measure .002 in. (0.05
mm) less than clearance in Step 11.
c.
Align shim(s) on cage.
d. Align bearing cage retainer on shim(s).
TA099442
Go on to Sheet 12
4-318
