TM 10-3930-641-34-2
DRIVE SHAFTS DISASSEMBLY / ASSEMBLY (CONT)
(Sheet 12 of 15)
LOCATION/ITEM
ACTION
REMARKS
16.
Six capscrews (23) and washers (15)
Install. Tighten evenly to a torque of 65 to
85 lb. ft. (88 to 115 N-m).
17.
Bearing cage assembly (16)
Lower bearing cage onto splined end of front
shaft.
18.
Yoke (24)
Install on top of bearing cage.
19.
Retainer (28)
Align on shaft without seal or shims.
20.
Three capscrews (23)
a. Install without washers. Tighten to a
torque of 50 to 70 lb. (68 to 95 Nm).
b. Remove capscrews and retainer.
21.
Spacing of yoke (24) and splined
shaft
right, measure distance between end of
shaft and inner face of yoke.
b. Record this measurement.
TA099443
Go on to Sheet 13
4-319