TM 10-3930-675-10-1
PREPARATION FOR TRANSPORT - CONTINUED
0007 00
PLACING CAB IN TRANSPORT POSITION - CONTINUED
NOTE
It may be necessary to turn on the auxiliary pump and slowly move the cab to aid in releasing the cab
pins.
c. Release cab by removing two retaining pins and pins from cab subframe.
RETAINING PIN
PIN
CAB
SUBFRAME
CAB IN OPERATIONAL POSITION
350-089
d. Remove two retaining pins and remove handrail.
NOTE
The auxiliary pump runs for approximately four minutes. If the pump shuts off, it may be necessary
to push auxiliary pump switch on instrument panel inside cab to restart auxiliary pump.
e. Push auxiliary pump switch on instrument panel inside cab to start auxiliary pump.
f. Open door of remote hydraulic control compartment.
g. Pull cab lift/lower lever to raise cab transport lift until cab track is level with current cab position.
HANDRAIL
CAB
TRANSPORT
SAFETY
LIFT
LOCKS
CAB
TRACK
RETAINING
PIN
0007 00-3
