TM 10-3930-675-10-1
PREPARATION FOR TRANSPORT - CONTINUED
0007 00
PLACING CAB IN TRANSPORT POSITION - CONTINUED
l. Reinstall handrail, now configured as a ladder, on cab in transport position. Secure with two retaining pins.
m.Push auxiliary pump switch on instrument panel inside cab to turn pump OFF.
n. To continue preparation for transport, refer to Fold Boom Support in this work package.
RETAINING PINS
LADDER
Return Cab to Operational Position.
2.
a. Run RTCH engine at idle.
b. Push auxiliary pump switch on instrument panel inside cab to start auxiliary pump.
c. Remove two retaining pins and ladder.
d. Open door of remote hydraulic control compartment.
e. Release cab by removing two retaining pins and pins from cab.
f. Pull side movement lever to move cab free of frame lock.
g. Pull cab lift/lower lever until cab is fully raised.
h. Push cab side movement lever until cab has moved all the way to center position.
i. Push cab lift/lower lever to lower cab transport lift.
NOTE
Cab side movement lever may need to be operated to move cab slightly side to side, to enable
installation of pins.
Pins should be installed from the rear. Install rear pin first.
j. Lock cab in operational position by installing two pins and retaining pins to cab subframe.
k. Close and latch door of remote hydraulic control compartment.
l. Push auxiliary pump switch on instrument panel inside cab to turn pump OFF.
0007 00-5