TM 10-3930-675-10
0007 00-17
PREPARATION FOR TRANSPORT - CONTINUED
0007 00
AIR TRANSPORT - CONTINUED
s.
Turn bogie wheels retaining collar ¼ turn clockwise to unlock bogie wheels. If retaining collar is still tight, use han-
dle stowed forward of bogie wheels to rotate shaft.
t.
Push bogie wheels lever to lower bogie wheels; ensure wheels are lowered sufficiently to apply ground pressure.
u.
Open shutoff valve #5 inside remote hydraulic control compartment by turning handle 90° counterclockwise. Bogie
wheels will lower further and apply correct amount of ground pressure.
WARNING
Always use a ground guide (load master) and do not exceed 1 mph (1.6 kph) speed when driving RTCH up
ramps in preparation for air transport. Failure to use a ground guide may result in an accident, causing death
or injury to personnel or damage to equipment.
CAUTION
Oversteering will damage dolly and bogie wheels.
v.
Using first gear and two-wheel steering mode, slowly drive RTCH forward up ramps and position inside aircraft. DO
NOT exceed 1 mph (1.6 kph) speed. Only slight steering corrections (no more than ¼ turn of steering wheel) are
allowed during loading.
w.
Lower boom support to the maximum onto the frame (refer to Placing Boom Support in Transport Position).
RETAINING
COLLAR
(UNLOCKED)
SHAFT
