AIR TRANSPORT - CONTINUED - TM-10-3930-675-10

AIR TRANSPORT - CONTINUED - TM-10-3930-675-10_103

q. Open remote hydraulic control compartment

TM-10-3930-675-10 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
71

TM 10-3930-675-10 0007 00-18 PREPARATION FOR TRANSPORT - CONTINUED 0007 00 AIR TRANSPORT - CONTINUED x. Rotate bogie wheels retaining collar ¼ turn clockwise to lock bogie wheels in position. It may be necessary to screw shaft down to take up slack in bogie wheels lock. y. Close shutoff valve #5 by turning handle 90° clockwise. z. Shut down RTCH engine. aa. Tie boom to RTCH frame. ab. Secure RTCH to tiedown locations inside aircraft IAW tiedown instructions on RTCH data plate and on aircraft. 2. Unload RTCH from C-5 Aircraft. a. Remove all tiedowns. b. Open shutoff valve #5 inside remote hydraulic control compartment by turning handle 90° counterclockwise. c. Rotate bogie wheels retaining collar ¼ turn clockwise to unlock bogie wheels. d. Raise boom support to 30° mark on frame (refer to Placing Boom Support in Transport Position). WARNING Always use a ground guide (load master) and do not exceed 1 mph (1.6 kph) when backing RTCH down air- craft ramps. Failure to use a ground guide may result in an accident, causing death or injury to personnel or damage to equipment. CAUTION Oversteering will damage dolly and bogie wheels. e. Using two-wheel steering mode, slowly back RTCH down ramps. DO NOT exceed 1 mph (1.6 kph) speed. Only slight steering corrections (no more than ¼ turn of steering wheel) are allowed during unloading. f. Inside remote hydraulic control compartment, close shutoff valve #5. g. Inside remote hydraulic control compartment, pull bogie wheels lever to fully raise bogie wheels. HANDLE (STOWED) RETAINING COLLAR (LOCKED-BOGIE WHEELS DOWN) SHAFT

Privacy Statement
Press Release
Contact