TM 10-3930-675-10
0007 00-5
PREPARATION FOR TRANSPORT - CONTINUED
0007 00
PLACING CAB IN TRANSPORT POSITION - CONTINUED
b.
Push auxiliary pump switch on instrument panel inside cab to start auxiliary pump.
c.
Remove two retaining pins and remove ladder.
d.
Open door of remote hydraulic control compartment.
e.
Release cab by removing two retaining pins and pins from cab.
f.
Pull side movement lever to move cab free of frame lock.
g.
Pull cab lift/lower lever until cab is fully raised.
h.
Push cab side movement lever until cab has moved all the way to center position.
i.
Push cab lift/lower lever to lower cab transport lift.
NOTE
• Cab side movement lever may need to be operated to move cab slightly side-to-side, to enable installation of
pins.
• Pins should be installed from the rear. Install rearmost pin first.
j.
Lock cab in operational position by installing two pins and retaining pins to cab subframe.
k.
Close and latch door of remote hydraulic control compartment.
l.
Push auxiliary pump switch on instrument panel inside cab to turn off pump.
m. Install handrail on cab with two retaining pins.
