TM 10-3930-675-20-1
0007 00-67
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
Table 12. Error Code 1332 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1332 - Injector Circuit Failure -
Continued
8. Place ignition switch to OFF
position
and
disconnect
internal actuator harness from
injector solenoid connector
and
disconnect
injector
solenoid wires from solenoid.
a. Measure resistance from
pin A (or 1) of injector
solenoid
connector
to
injector wire pigtail nut.
Resistance should be less
than 10 ohms.
a. If resistance is as specified,
notify
SRA
to
replace
internal actuator harness.
b. If resistance is not as
specified, replace injector
solenoid wires.
b. Measure resistance from
pin B (or 2) of injector
solenoid
connector
to
injector wire pigtail nut.
Resistance should be less
than 10 ohms.
a. If resistance is as specified,
notify
SRA
to
replace
internal actuator harness.
b. If resistance is not as
specified, replace injector
solenoid wires.
<10 OHMS
