TM 10-3930-675-20-1
0007 00-62
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
WARNING
Injector solenoids receive high voltage when engine is operating. To avoid personal injury or death from
electrical shock, do not wear jewelry or damp clothing, and do not touch injector solenoids or solenoid wires
when engine is operating.
Table 12. Error Code 1332 - Injector Circuit Failure Troubleshooting Procedures.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1332 - Injector Circuit Failure
1. Place ignition switch to OFF
position
and
disconnect
actuator harness from engine
ECU.
a. Inspect actuator harness
and ECU connector for
dirty,
corroded,
bent,
broken, pushed back, and
extended pins.
Clean and repair connector(s) as
required (WP 0111 00).
b. Check actuator harness and
ECU connector for dirt or
moisture in or on the
connector and for missing
or
damaged
connector
seals.
Remove dirt and moisture from
connector. Replace missing or
damaged connector seals (WP
0111 00).
2. Place ignition switch to OFF
position
and
disconnect
actuator harness from engine
ECU and 15-pin connector at
front of engine below rocker
arm cover. Install jumper wire
from pin 7 to pin 8 at 15-pin
connector, actuator harness
side.
3. Measure resistance from
actuator harness connector
pin 26 to pin 36. Resistance
should be less than 10 ohms.
a. If resistance is not as
specified, repair or replace
connectors (WP 0111 00).
b. If engine harness requires
replacement, notify SRA.
