Error Code 1331 - Injector Circuit Failure - Continued

Error Code 1331 - Injector Circuit Failure - Continued - TM-10-3930-675-20-1_175

Error Code 1331 - Injector Circuit Failure - Continued - TM-10-3930-675-20-1_177

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
149

TM 10-3930-675-20-1 0007 00-58 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 Table 11. Error Code 1331 - Injector Circuit Failure Troubleshooting Procedures - Continued. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1331 - Injector Circuit Failure - Continued b. Check internal actuator harness and injector solenoid connector for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 7. Place ignition switch in OFF position and, with rocker arm cover removed, disconnect actuator harness from 15-pin connector and injector solenoid wires from no. 2 injector solenoid. a. Measure resistance from 15-pin connector pin 1 (or A) to each injector pigtail nut that connects the no. 1 injector (resistance to one of these nuts must be within specifications). Resistance should be less than 10 ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If internal actuator harness requires replacement, notify SRA. b. Measure resistance from 15-pin connector pin 2 (or B) to each injector pigtail nut that connects the no. 1 injector (resistance to one of these nuts must be within specifications). Resistance should be less than 10 ohms. If resistance is not as specified, notify SRA to replace internal actuator harness.

Privacy Statement
Press Release
Contact