TM 10-3930-675-20-1
0007 00-53
ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED
0007 00
Table 10. Error Code 1325 - Injector Circuit Failure Troubleshooting Procedures - Continued.
MALFUNCTION
TEST OR INSPECTION
CORRECTIVE ACTION
Error Code 1325 - Injector Circuit Failure -
Continued
a. Measure resistance from
pin 1 (or A) on solenoid
connector to engine block
ground. Resistance should
be greater than 100k ohms.
If resistance is not as specified,
notify SRA to replace internal
actuator harness.
b. Measure resistance from
pin 2 (or B) on solenoid
connector to engine block
ground. Resistance should
be greater than 100k ohms.
If resistance is not as specified,
notify SRA to replace internal
actuator harness.
11.Place ignition switch to OFF
position and, with rocker arm
cover removed, disconnect
no. 6 injector solenoid from
internal actuator harness.
12.Measure resistance from post
to
post
on
solenoid.
Resistance should be 0.5-1.5
ohms.
a. If resistance is as specified,
replace engine ECU (WP
0078 00).
b. If resistance is not as
specified,
notify
DS
Maintenance
to
replace
injector.
>100K OHMS
