Table 11. Error Code 1331 - Injector Circuit Failure Troubleshooting Procedures

Error Code 1325 - Injector Circuit Failure - Continued - TM-10-3930-675-20-1_171

Error Code 1331 - Injector Circuit Failure - Continued - TM-10-3930-675-20-1_173

TM-10-3930-675-20-1 Rough Terrain Container Handler (RTCH): RT 240; 53 000 Lb Capacity; 4x4 Manual
Page Navigation
145

TM 10-3930-675-20-1 0007 00-54 ENGINE FUEL INJECTOR CIRCUITS TROUBLESHOOTING - CONTINUED 0007 00 WARNING Injector solenoids receive high voltage when engine is operating. To avoid personal injury or death from electrical shock, do not wear jewelry or damp clothing, and do not touch injector solenoids or solenoid wires when engine is operating. Table 11. Error Code 1331 - Injector Circuit Failure Troubleshooting Procedures. MALFUNCTION TEST OR INSPECTION CORRECTIVE ACTION Error Code 1331 - Injector Circuit Failure 1. Place ignition switch to OFF position and disconnect actuator harness from engine ECU. a. Inspect actuator harness and ECU connector for dirty, corroded, bent, broken, pushed back, and extended pins. Clean and repair connector(s) as required (WP 0111 00). b. Check actuator harness and ECU connector for dirt or moisture in or on connector and for missing or damaged connector seals. Remove dirt and moisture from connector. Replace missing or damaged connector seals (WP 0111 00). 2. Place ignition switch to OFF position and disconnect actuator harness from engine ECU and 15-pin connector at front of engine below rocker arm cover. Install jumper wire from pin 3 to pin 4 at 15-pin connector, actuator harness side. 3. Measure resistance from actuator harness connector pin 8 to pin 7. Resistance should be less than 10 ohms. a. If resistance is not as specified, repair or replace connectors (WP 0111 00). b. If engine harness requires replacement, notify SRA.

Privacy Statement
Press Release
Contact